A spare o-ring is available that is NOT the same as the installed one. You only need to have one of the seals in place. The included one is a hard-pressed fibre seal (green) that is long-lasting but will need a spanner to tighten. The spare is a EPM seal (black) and is softer, it will allow hand tightening but will become damaged more quickly.
These custom-made brass soda stream adapters allow you to use a 400g Soda Stream bottle with mini regulators (it screws in where a 16g CO2 bulb would). It is best to use this item with a remote gas line so the gas bottle doesn't need to be directly connected to the keg! If you have an iKegger 2.0 Mini Regulator you can get the sodastream adapter and remote gas line boxed here.
The adapter screw directly into the 16g bulb socket so swapping back and forward between bulbs and sodastream bottle is quick and easy.
- Ensure the green seal is inside the adapter and not damaged
- Screw the adapter onto the gas bottle loosely almost all the way then hold it in place.
- Screw the regulator onto the adapter finger tight
- Use a spanner to tighten the last 1/4 turn of the adapter onto the gas bottle quickly to avoid losing any gas.
The Soda Stream bottle holds the equivalent of 25 x 16g disposable cartridges and can be swapped for a full one for $19 from your nearest retailer (see this map for your closest exchange location in Australia)
You can buy your initial Soda Stream Gas Bottle from us or from your closest retailer.
These are much more cost effective than 16g canisters while still being portable and small enough to take with you.
See An Installation Video Below
THIS ADAPTER PRESSES THE GAS RELEASE VALVE ON THE SODA STREAM BOTTLE. SCREWING THE ADAPTER ON ALL THE WAY WITHOUT THE REGULATOR IN PLACE WILL CAUSE YOU TO LOSE A LOT OF GAS!